L46A1 Mast Section The part of the tower where the wire rope needs attention
When using tower hoist rental equipment, safety checks should be done in all parts. Although the wire rope should be fully tested, special attention should be paid to the following parts: wire rope movement and fixed initial and end parts; A segment of the rope that shows the pulley set or bypasses the pulley; In the case of repeated operation of the mechanism, special attention should be paid to any part of the pulley bypassed during the lifting of the mechanism(supplementary parts); A rope segment located on a balanced pulley; Rope segments that may cause wear due to external factors(such as hatches); Internal inspection of corrosion and fatigue(supplement). The inspection structure shall be recorded in the equipment inspection record book.
The part of the rope end(other than the cable) that is drawn from the fastening end should be examined, as fatigue(wire breakage) and corrosion are dangerous in this part, as well as deformation and wear of the fastener itself.
Similar tests are carried out for the use of a clamping or forging rope end fixation device, and for cracks in the rope strap material and the possibility of sliding between the rope strap and the steel boat rope.
L46A1 Mast Section L46A1 mast section good at in this field
